P0442 means the engine computer detected a small leak, about 0.040 inch across, in the EVAP system that captures fuel vapor. A loose, cracked or worn gas cap is the most common cause, then a cracked hose. The car is safe to drive, but the light stays on until the leak is fixed and retested.
| Code | P0442 |
|---|---|
| Meaning | EVAP System Leak Detected (Small Leak) |
| Severity | Fix soon |
| Can I keep driving? | Yes. The car is safe to drive. Fix it so you pass emissions and avoid fuel vapor leaks. |
| Most common cause | Loose, cracked or worn gas cap |
| Difficulty | Easy DIY |
What does P0442 mean?
The computer checks the EVAP system for leaks by sealing it and watching how fast the pressure changes. A leak the size of a 1 mm hole is enough to fail that check and set P0442. It sits between P0456, a much smaller leak, and P0455, a large one. A small leak is still a real gap, so the cause is often something you can find without special tools.
The leak test runs only under set conditions. Most cars need a cold soak overnight, an outside temperature in a moderate range and a tank roughly between 15 and 85 percent full, and the limits vary by maker. After a repair, the computer might not retest for several days, so the light does not go out when the leak is fixed.
P0442 symptoms
- Check engine light, often the only symptom.
- A faint fuel smell in some cases, usually near the rear wheel or fuel door.
- Failed emissions test.
- Normal engine performance and fuel economy.
What causes P0442?
- Loose, cracked or worn gas cap: the number one cause. Wear on the seal or a cap not clicked shut is enough for a leak this size.
- Cracked EVAP hose: rubber lines near the canister and engine bay harden and split, especially at the bends.
- Leaking purge or vent valve: the seat inside the valve wears and passes air when it should be sealed.
- Rusted or damaged filler neck: common on older cars in regions where roads are salted.
- Cracked charcoal canister: less common, but road debris and age will crack it.
- Leaking tank seal: rare, usually the gasket on the fuel pump module.
How to fix P0442
- Re-seat the cap: tighten it until it clicks, clear the code and drive for a few days. If the light stays off, the cap was the problem.
- Replace a worn cap: if the seal is cracked or flattened, a new cap is the cheapest repair on the list. Pick one made for your vehicle.
- Inspect hoses and the filler neck: look for splits, loose clamps and rust holes you can see from under the car.
- Smoke test: this is the standard diagnosis. A smoke machine feeds harmless vapor into the EVAP service port, and smoke curling out of a hose or fitting marks the leak.
- Repair and retest: replace the part the smoke points to, clear the code and let the car complete a leak test. A scan tool that reads EVAP readiness (see how to use an OBD2 scanner) shows when the monitor has run.
Can you drive with a P0442 code?
Yes. A small EVAP leak does not affect how the engine runs or the safety of the car. The cost of waiting is a failed inspection and a small amount of vapor released into the air. A flashing check engine light is a different fault, so stop if yours flashes. If you smell strong fuel or see a wet spot under the car, get it checked right away.
Related codes
- P0456: EVAP System Leak Detected (Very Small Leak)
- P0455: EVAP System Leak Detected (Large Leak)
- P0441: EVAP System Incorrect Purge Flow
- P0496: EVAP System High Purge Flow
- P0446: EVAP System Vent Control Circuit
- P0457: EVAP System Leak Detected (Fuel Cap Loose/Off)
FAQ
Can a loose gas cap cause P0442?
Yes. A loose or worn gas cap is the single most common cause. Tighten it until it clicks, clear the code and drive for a few days. If the light does not return, the cap was the leak.
How long does P0442 take to go away after a repair?
Several days in most cases. The computer runs the EVAP test only after a cold soak with the tank partly full, so it has to find those conditions first. Most cars turn the light off after a few passing tests.
Is P0442 expensive to fix?
Often not. A gas cap or short hose fixes many cars. The cost goes up for a leaking canister or a rusted filler neck, and the smoke test adds a small shop fee. Rule out the cap before paying for diagnosis.
P0442 vs P0455: what is the difference?
Leak size. P0442 is a small leak around 0.040 inch, while P0455 is a large one, often a missing cap or a disconnected hose. Both follow the same diagnosis, but P0455 is usually quicker to find.
Got more than one code? Enter them all in the OBD2 code lookup to see each meaning, severity and first check side by side. If you still need a reader, start with the best OBD2 scanners for beginners, then follow how to use an OBD2 scanner to pull freeze frame data before you clear anything.
Sources & References
- SAE J2012, diagnostic trouble code definitions: https://www.sae.org/standards/content/j2012_201612/
- California Air Resources Board, on-board diagnostics: https://ww2.arb.ca.gov/our-work/programs/obd-board-diagnostic-program
- EPA, vehicle emissions inspection and maintenance: https://www.epa.gov/state-and-local-transportation/vehicle-emissions-inspection-and-maintenance-im
How we reviewed this article
This article was researched against manufacturer records and editorially reviewed before publishing. We accept no payment for coverage. Some guides contain affiliate links; see our affiliate disclosure.


