Skip to content
Guides

P0455 Code: Large EVAP Leak Causes and How to Fix It

P0455 is a large EVAP leak, most often a loose, missing or wrong gas cap. Check the cap and hoses, then smoke test if the code returns.

Updated November 19, 2026
Check engine light on a car dashboard with a fuel cap icon

P0455 means the engine computer found a large leak in the EVAP system, the sealed network that holds fuel vapor from the tank. A missing, loose or wrong gas cap is the most common cause, followed by a disconnected hose. The car is safe to drive, but fix it to pass emissions and stop vapor escaping.

P0455 at a glance
Code P0455
Meaning EVAP System Leak Detected (Large Leak)
Severity Fix soon
Can I keep driving? Yes. The car is safe to drive. Fix it so you pass emissions and avoid fuel vapor leaks.
Most common cause Loose, missing or wrong gas cap
Difficulty Easy DIY

What does P0455 mean?

During its EVAP self-test the computer seals the system and tries to build a vacuum. With a large leak it cannot get there at all. Because the failure is gross, P0455 usually points to something you can see or feel, not a pinhole. For smaller leaks the computer sets P0442 or P0456.

The test runs only when the car has cold soaked for several hours and the tank is roughly between 15 and 85 percent full, with limits that differ by maker. A recent refuel with the cap left off is the classic trigger. After a fix, the light can take several days to turn off, because the computer has to run and pass the test again.

P0455 symptoms

  • Check engine light.
  • A fuel smell around the car, more noticeable after parking or refueling.
  • Failed emissions test.
  • No change in driveability. The engine runs as it did before.

What causes P0455?

  1. Loose, missing or wrong gas cap: the top cause by a wide margin. It happens after refueling, especially with a cap that is not made for your car.
  2. Disconnected or cracked EVAP hose: a line that popped off a fitting, or one knocked loose during recent repairs, gives a large leak at once.
  3. Damaged filler neck: rust holes or a bent neck after a collision stop the cap from sealing.
  4. Cracked charcoal canister: stones and corrosion under the car can break the housing.
  5. Faulty purge or vent valve: a valve stuck open can keep the system from holding vacuum. Compare P0441, which flags a purge flow problem instead.

How to fix P0455

  1. Check the cap: make sure it is on, undamaged and tightened until it clicks. If it has a cracked tether or seal, replace it with the correct cap.
  2. Look at the filler neck: check for rust, dents and a loose neck-to-tank connection.
  3. Trace the EVAP lines: follow the hoses from the filler neck and canister to the engine bay, looking for pulled-off ends. If the car was recently serviced, start at the area the mechanic worked on.
  4. Inspect the canister and valves: look near the tank for cracks and check that the purge and vent valves are plugged in.
  5. Smoke test: if nothing obvious turns up, a shop will smoke test the system. A large leak shows quickly, often within seconds.

Can you drive with a P0455 code?

Yes. The engine and brakes are unaffected, so the car can be driven normally. Fix it soon, because a large leak lets raw fuel vapor into the air and the car will fail an emissions test. If you smell strong gasoline, especially liquid fuel or a smell inside the cabin, have the fuel system checked before driving.

  • P0456: EVAP System Leak Detected (Very Small Leak)
  • P0442: EVAP System Leak Detected (Small Leak)
  • P0441: EVAP System Incorrect Purge Flow
  • P0496: EVAP System High Purge Flow
  • P0446: EVAP System Vent Control Circuit
  • P0457: EVAP System Leak Detected (Fuel Cap Loose/Off)

FAQ

Can a bad gas cap cause P0455?

Yes. A missing or loose cap is the number one cause of P0455 because it opens the whole system to air. Tighten it until it clicks or replace a damaged one, then drive for several days while the computer retests.

Will P0455 clear itself?

Sometimes. If a loose cap was the cause and you tightened it, the light usually goes out after the computer runs and passes the leak test a few times. A real hose or canister leak keeps the code coming back.

Is P0455 serious?

No, it is a low-severity emissions fault. It will not damage the engine. The risks are failing inspection and releasing fuel vapor, so the repair is worth doing, but it is not urgent in the way a misfire is.

Why did P0455 appear right after I filled up?

The cap was probably not closed fully. When the cap is left loose the system leaks heavily, and the test fails on the next cold start. Close the cap until it clicks, clear the code and recheck after a few days.

Got more than one code? Enter them all in the OBD2 code lookup to see each meaning, severity and first check side by side. If you still need a reader, start with the best OBD2 scanners for beginners, then follow how to use an OBD2 scanner to pull freeze frame data before you clear anything.

Sources & References

  1. SAE J2012, diagnostic trouble code definitions: https://www.sae.org/standards/content/j2012_201612/
  2. California Air Resources Board, on-board diagnostics: https://ww2.arb.ca.gov/our-work/programs/obd-board-diagnostic-program
  3. EPA, vehicle emissions inspection and maintenance: https://www.epa.gov/state-and-local-transportation/vehicle-emissions-inspection-and-maintenance-im
Avatar photo
About the Author

James Kowalski

Automotive Writer

James Kowalski is a former ASE-certified mechanic turned automotive writer. With 10 years of hands-on experience in repair shops and dealerships, James specializes in practical topics like tires, brakes, performance upgrades, and truck accessories. He believes in empowering readers with the knowledge to make informed decisions about their vehicles, whether they're weekend warriors or daily commuters.

More from James Kowalski

How we reviewed this article

This article was researched against manufacturer records and editorially reviewed before publishing. We accept no payment for coverage. Some guides contain affiliate links; see our affiliate disclosure.